What to Expect from This Upscale Kit
The Poseidon Model 1/72 Upscale RG Crossbone X-1 is a third-party resin conversion kit that enlarges and details the original Real Grade design. It's a pre-order item with an estimated arrival in November 2026, available through Cool Dragon Hobby's rare and limited selection. Because this is an upscaled interpretation rather than a standard injection-molded kit, your build approach should account for resin-specific fitting and finishing steps.
Kit Details from the Listing
- (Pre-Order) Poseidon Model 1/72 Upscale RG Crossbone X-1 (ETA: November 2026): Brand: Poseidon Model, Scale: 1/72, an upscaled interpretation of the RG Crossbone X-1 The 1/72 scale is larger than the original 1/144 RG, meaning parts may not fit perfectly out of the box. Expect to trim, sand, and test-fit joints.

(Pre-Order) Poseidon Model 1/72 Upscale RG Crossbone X-1 (ETA: November 2026) - (Pre-Order) Poseidon Model 1/72 Upscale RG Crossbone X-1 (ETA: November 2026): Pre-order item with estimated arrival in November 2026. Includes standard configuration as shown. Since this is a pre-order, you have time to prepare tools and workspace. The 'standard configuration' likely means no extra photo-etch or metal parts are included.
Build Workflow for the Upscale Crossbone X-1
The following steps are based on common practices for third-party resin conversion kits. The supplied product information does not include specific instructions, so treat these as general guidance and always refer to the kit's own manual if available.
- 1. Inspect and clean parts: Check each resin piece for flash, mold lines, and warping. Wash parts in warm soapy water to remove mold release agents. Let them dry completely before any sanding or gluing.
- 2. Dry-fit before gluing: Assemble major sections (torso, arms, legs) without adhesive to identify tight joints or gaps. Mark areas that need sanding or shimming. This is especially important for an upscale conversion where tolerances may vary.
- 3. Pin or reinforce joints: Resin kits often benefit from pinning (drilling and inserting metal wire) at stress points like hip joints and shoulder connections. This adds durability, especially if you plan to pose the model.
- 4. Use quality CA glue or epoxy: Standard plastic cement may not bond resin well. Use cyanoacrylate (CA) glue for most joints and two-part epoxy for larger structural bonds. Work in a ventilated area.
- 5. Fill and sand seams: Apply putty to gaps and sand progressively through finer grits (400 to 1000) for a smooth surface. This is where the upscaled scale shows its potential for detail, but also its need for careful finishing.
- 6. Prime and paint: Use a primer designed for resin (such as Mr. Surfacer or a lacquer-based primer) to ensure paint adhesion. The Crossbone X-1's color scheme can be built up with your preferred acrylic or lacquer paints.
What the Listing Does Not Confirm
The product listing does not specify the material (resin vs. ABS), the presence of a decal sheet, or whether the kit includes a display base. It also does not confirm a manual or assembly instructions. Given these unknowns, plan to rely on your own modeling experience and reference photos of the original RG Crossbone X-1 for color placement and decal placement.


